
63230-216-229-B1-
00_frontcover.fm/3
Schneider Electric
© 2007 Schneider Electric. All Rights Reserved. 63230-216-229-B1
Safety Instructions 0
FCC Notice
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his
own expense. This Class A digital apparatus complies with Canadian ICES-003.
Safety Symbols and Messages
Read these instructions carefully and look at the equipment to become familiar with
the device before trying to install, operate, service or maintain it. The following
special messages may appear throughout this bulletin or on the equipment to warn
of potential hazards or to call attention to information that clarifies or simplifies a
procedure.
Risk of Electric Shock
The addition of either symbol to a “Danger” or “Warning” safety label on a device
indicates that an electrical hazard exists, which will result in death or personal injury
if the instructions are not followed.
ANSI symbol IEC symbol
Safety Alert
This is the safety alert symbol. It is used to alert you to potential personal injury
hazards and prompt you to consult the manual. Obey all safety instructions that
follow this symbol in the manual to avoid possible injury or death.
Safety Messages
DANGER
DANGER indicates an imminently hazardous situation which, if not avoided,
will result in death, serious injury or property damage.
WARNING
WARNING indicates a potentially hazardous situation which, if not avoided,
could result in death, serious injury or property damage.
CAUTION
CAUTION indicates a potentially hazardous situation which, if not avoided,
minor or moderate injury or property damage.
Important Notes
Restricted Liability
Electrical equipment should be serviced and maintained only by qualified personnel.
No responsibility is assumed by Schneider Electric for any consequences arising out
of the use of this manual. This document is not intended as an instruction manual for
untrained persons.
Device Operation
The user is responsible for checking that the rated characteristics of the device are
suitable for its application. The user is responsible for reading and following the
device’s operating and installation instructions before attempting to commission or
maintain it. Failure to follow these instructions can affect device operation and
constitute a hazard for people and property.
Protective Grounding
The user is responsible for compliance with all the existing international and national
electrical codes concerning protective grounding of any device.
Comentarios a estos manuales