Black Box IC109A-R2 Manual de instalación descargar pdf (Pagina 113)

10763230-216-229-B1

Use

SFT2841 Software

Mimic-Diagram Editor

Presentation

Description

SFT2841 Sepam™ setting and operating software includes a mimic-diagram editor

you can use to personalize the mimic diagram for local control on the mimic-based

UMI of Sepam™ Series 80 units.

A mimic-diagram or single-line diagram is a simplified diagram of an electrical

installation. It is made up of a fixed background on which symbols and

measurements are placed.

The mimic-diagram editor can be used to:

b create a fixed bitmap background (128 x 240 pixels) using standard drawing

software

b create animated symbols or use predefined animated symbols to represent

the electrotechnical devices or other objects

b assign the logic inputs or internal status conditions that modify the animated

symbols. For example, the logic inputs for the circuit-breaker position must be

assigned to the circuit-breaker symbol to enable the display of the open and

closed conditions

b assign the logic outputs or internal status conditions that activate when

opening or closing commands are issued for the symbol

b display current, voltage, and power measurements on the mimic diagram

Mimic-Diagram and Symbols

The symbols making up the mimic-diagram constitute the interface between the

mimic-based UMI and other Sepam™ control functions.

There are three types of symbols:

b A Fixed symbol: represents the electrotechnical devices that are neither

animated or controlled such as a transformer

b An Animated symbol: with one or two inputs represents the electrotechnical

devices that change on the mimic diagram, depending on the symbol inputs,

but cannot be controlled via the Sepam™ mimic-based UMI.

This type of symbol is used for switch-disconnectors without remote controls.

b A Controlled symbol: with one or two inputs/outputs represents the

electrotechnical devices that change on the mimic diagram, depending on the

symbol inputs, and can be controlled via the Sepam™ mimic-based UMI. This

type of symbol is used for circuit breakers

The symbol outputs are used to control the electrotechnical device:

v directly via the Sepam™ logic outputs

v by the switchgear control function

v by logic equations or the Logipam program

Local Control using Symbols

Controlled - 1 input/output and Controlled - 2 input/output symbols are used to

control the switchgear that corresponds to the symbol via the Sepam™ mimic-based

UMI.

Control Symbols with One Output

Controlled - 1 input/output symbols have one control output. The output remains

in the last state to which it was commanded.

A new command causes in a change in the output state.

Control Symbols with Two Outputs

Controlled - 2 input/output symbols have two control outputs for opening and

closing of the symbolized device. A command on the mimic-based UMI sends a 300

ms pulse on the controlled output.

Blocking Commands

Controlled - 1 input/output and Controlled - 2 input/output symbols have two

blocking inputs that block opening and closing commands when set to "1". This

makes it possible to create interlocking systems or other command-disabling

systems that the UMI takes into account.

1 2 ... 108 109 110 111 112 113 114 115 116 117 118 ... 163 164

Comentarios a estos manuales

Sin comentarios

Black Box IC109A-R2 Manual de instalación Pagina 113

Comentarios a estos manuales