Black Box IC108A Guía de usuario descargar pdf (Pagina 109)

Advant

Smart Device (HART

) Interface User’s Guide

Section 5.4.1 User Repair

3BUR 001 085R0001 REV A 5-5

10. Ensure that the board contacts mate properly with the contacts in the rear plane and screw

the locking mechanism in place.

11. Boards which can be replaced during operations are initialized automatically by the system

and the fault indicating LED extinguishes automatically after approximately 10 seconds.

12. Perform a function test on the new board.

Additional Aspects on Individual Board Types

Table 5-1 lists AC460 subrack boards (applied in the controller subrack). Descriptions of these

types are referred individually in the table.

The S100 I/O boards are described in the S100 I/O User’s Guide.

5.4.1.2 Smart Device Removal and Installation Procedures

Smart Device Removal

To remove a smart device for servicing or replacement, disconnect all field wiring from the

smart device at the screw terminations on the analog termination panel if connected to one, the

SHIM, and the smart device itself.

Table 5-1. Replacement Aspects on Boards in the Controller Subrack

Board Type - Jumpering Comments

CI532V02

MVI

Submodule

No operational jumpering on module S1

used for testing (no jumpers).

X6 is a debug communications port

used for testing.

- Replacement with power applied is possible.

- Described in:

Advant Controller 410 and 460

User’s Guides

-May affect serial I/O communication with

device.

SC510

COMM 1

No jumpering - Replacement with power applied is possible.

1 2 ... 104 105 106 107 108 109 110 111 112 113 114 ... 117 118

Sin comentarios

Black Box IC108A Guía de usuario Pagina 109