
Advant
®
Smart Device (HART
®
) Interface User’s Guide
Section 4.3.4 Smart Device I/O Display
3BUR 001 085R0001 REV A 4-11
4.3.4 Smart Device I/O Display
The Smart Device I/O Display shown in Figure 4-8 provides information regarding the
transmitter and CCF tag names and digitally read value (mA regardless of engineering units
scale) for up to eight smart transmitters on the selected SHIM network.
A value turns red to indicate the smart device is inactive (down), and red Xs in the value column
indicate the port is down.
The PAGE FORWRD softkey calls up the Smart Device I/O Display for the next higher
numbered SHIM network, and the PAGE BACK softkey calls up the Smart Device I/O Display
for the next lower numbered SHIM network.
From the Smart Device I/O Display, you can either return to the Smart Device Network
Overview Display by selecting the DEVICE OVER softkey key or call up the Smart Device
Tuning Overview Display for a specific smart transmitter by selecting the desired transmitter’s
tag name in response to the prompt above the softkeys.
Figure 4-8. Smart Device I/O Display
SYSTEM STATUS
DEVICE I/O
07 JAN 97 09:25:36
FETCH
ALARM
MSG
LAST
PAGE
DEVICE
OVER
QUIT
SMART DEVICE I/O
PORT ID = SDI_PORT1 PORT STATE = ACTIVE
I/O NETWORK: 01
SELECT SMART DEVICE TAG TO ACCESS DEVICE TUNING DISPLAY
PORT NO.: 1
DEVICE ID
CCF TAG DESCRIPTION VAL (MA)
1
2
3
4
5
6
7
8
HTFT-101
HTFT-111
HTFT-555
HTFT-605
HTFT-714
FTPID-101
FTPD-111
FT-555
FT-104
FTPD-155
COOLING FLOW PRESS
HOT H2O FLOW
FEED FLOW
EXIT STEAM FLOW
EXIT CHLORINE FLOW
4.0
15.4
19.7
3.6
11.4
PAGE
FORWRD
PAGE
BACK
Comentarios a estos manuales