Black Box IC108A Guía de usuario descargar pdf (Pagina 105)

Advant

Smart Device (HART

) Interface User’s Guide

3BUR 001 085R0001 REV A 5-1

Chapter 5 Maintenance

5.1 Introduction

This chapter explains configuration-related error codes that can be returned by the Advant Smart

Device (HART) Interface to the Advant OCS and reported as diagnostic messages on the

Diagnostic Message Display. For further information on Advant OCS diagnostics, refer to the

Subsystem Status and Diagnostics instruction book.

5.2 Hardware Indicators

5.2.1 CI532V02 MVI Submodule LEDs

The CI532V02 MVI (ModbusB) Submodule (Figure 5-1) has two status LEDs. The Fault (F)

LED will illuminate red to indicate a board fault and it is also on when the module is reset. The

Run (R) LED will illuminate green to indicate the module is running normally and port

characteristics have been properly set by the host CPU.

5.2.2 SHIM Indicators

As shown in Figure 2-15, the SHIM has 3 red diagnostic LEDs. The one on the front panel

flashes to indicate the SHIM passed its self test and is operational. The other LEDs are visible

through the ventilation slots in the top of the housing. The LED closest to the back of the

Figure 5-1. MVI Module Status LEDs

Red LED. Illuminates to indicate

a board malfunction.

Green LED. Indicates that the

module is running normally

532

host CPU

and port characteristics have

been properly set by the

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 117 118

Sin comentarios

Black Box IC108A Guía de usuario Pagina 105