
8
Coin/Token Sizes
The hoppers will automatically adjust to dispense coins/tokens in
size from 20-30 mm in diameter and 1.25 - 3.5 mm in thickness.
There is an option available to dispense smaller coins.
A nickel is approximately 21 mm, a quarter is approximately
25mm. A Susan B. Anthony is 28mm
Coin Control Hopper MKIV
Three green LED indicators are fitted on the hoppers and are
visible in the section where the coins exit the hoppers. From left
to right these are designated as follows:
1. Logic power supply on (12 & 24vdc present).
2. Security optical obstruction indicator -. Should be ”on”
when unit is OK.
3. Output indicator, indicates coin passing photo-sensor. This
is the optical sensor the coin will obstruct on its way out of
the hoppers. For normal operation LED # 3 will be off
until coins are dispensed.
The right & left hoppers have a removable coin
chute installed. Replacement hoppers are not
sent with this coin chute.
Left chute (P# AC2010-104)
Right chute (P# AC2010-114
HOPPER ERROR CODE DEFINITIONS
The DBCG-1 EPROM chips allow for the hoppers to run in a
one-hopper mode if one hopper goes down and the ability to
explain why that hopper was shut down. To access this mode
press the DUMP button while in the normal operating mode.
The meter display will disappear and be replaced by the error
readout. You will know if you are in the one-hopper mode if
only one hopper is dispensing coins, one hopper is full and
the other is empty, or that your far-left decimal point on the
light-up display is lit instead of the far-right. The most left
display (#1) is not used. The #2 & #3 display are for the left
hopper and #4 & #5 display are for the right hopper. Here
are the error code definitions:
01=Low coin.
02=Object stuck in optic window.
04=Did not pay enough coins.
10=Paid too many coins (2 max) Jackpot
protection!
An error read-out of “00100” states the left hopper was
shut down due to low coins. A read-out of “00003”
states an optic window failure and low coin was
detected. I.e. 01 + 02 = 03.
12 pin male
connector.
(located on
Motor
Coin counting
12vdc Power
Security LED.
(all systems
Coin
counting
LED.
Hopper
coin bin.
(Dump the
coins into
this hole.
1600 coins
max.)
I
nore
Left
Hopper
Right
Hopper
Comentarios a estos manuales