Black Box AC2000A Especificaciones descargar pdf (Pagina 32)

Problem:

D. The green LED on the Main

Logic Board is lit but the Light-

up display does not.

E. The bill validator accepts and

stacks the bills, but the meter

does not increase.

F. The bill validator accepts and

stacks the bills, and the meter

does increase.

G. The bill validator will not

pull in the bill and the

“Empty” LED is not lit.

H. The bill validator pulls in the

bill slightly then rejects it.

I. The bill validator red status

LED flashes a “5” error code.

J. The bill validator red status

LED flashes a “6 or 7” error

code.

K. The bill validators red status

LED is on steady but it still

will not accept the bill.

Solution:

1. Bad 5 or 12vdc regulator on the main logic board.

2. The hoppers are shorted.

3. Replace main logic board.

4. Replace hoppers.

1. Check continuity and for pin damage to the blue and yellow wires

on the validator harness.

2. Replace the validator wire harness.

3. Replace the validator.

1. Ensure the dip switch settings are still correct. (#3 “ON” only)

2. Check the continuity of the brown and purple wires on the hoppers

wire harness.

3. The hopper is jammed. Go to pgs.22-25 to un-jam the hoppers.

4. Replace the hoppers wire harness.

1. Ensure the orange wire going to the “Empty” LED is connected to

the + or the terminal with the red mark by it.

2. Check for 12vdc going to the orange and brown wires. If there is,

replace the LED.

3. Replace the main logic board.

4. Replace the bill validator.

5. Replace the validator wire harness.

1. Clean the validator. (pg.10)

2. Remove the lower housing (pg. 12) of the bill validator. Ensure the

center wheel spins freely. Push straight down on it slightly to

loosen.

3. Replace the bill validator.

1. Clean the validator optic LED’s. (See pg.10)

2. Ensure that all the wire harness plugs are plugged firmly into their

white female sockets.

3. Turn to the back page of this manual and check for a Coin

Acceptors branch in your area to repair your bill validator .

1. Take the bill stacker off the bill validator. Cycle the power on / off

using the switch on the main logic board and coast the silver push

bar so that it stops in its fully extended position. Blow out the area

behind the push bar with high pressure or canned air. Concentrate

on the encoder wheel in the area top center behind the push bar.

2. Turn to the back page of this manual and check for a Coin

Acceptors branch in your area to repair your bill validator .

1. Pull out the lower housing, see page 12 , and look for something

obstructing the bill path. (i.e. gum, papers, tickets, coins, etc.)

2. Look inside the Plexiglas case on the side of the bill validator.

Ensure that all the wire harness plugs are plugged firmly into their

white female sockets.

TROUBLESHOOTING GUIDE

TO USE THE TROUBLESHOOTING GUIDE, MATCH UP THE PROBLEM, THEN FOLLOW THE SOLUTION

SUGGESTIONS. After every step re-try operating the changer to see if the problem has been solved.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 44 45

Comentarios a estos manuales

Sin comentarios

Black Box AC2000A Especificaciones Pagina 32

Comentarios a estos manuales

Relacionado con productos y manuales para No Black Box AC2000A