Black Box AC2000A Especificaciones descargar pdf (Pagina 30)

NOTE: Before starting this procedure ensure the changer is plugged in, the ON/OFF switch is on,

the hoppers are full of coins, and all wire harnesses are connected securely and correctly.

The wires exiting the red connectors should point away from the board!!

Start here!

For a more detailed trouble shooting information proceed to the next section!

FOR TECHNICAL SERVICE OR TO OBTAIN A RETURN AUTHORIZATION

NUMBER CALL (888) 741-9840

ANY REPAIR RETURNED WITHOUT A RETURN AUTH. # WILL BE REFUSED!!

TECHNICAL FLOW DIAGRAM FOR THE AC2000 SERIES

IS THE

"EMPTY" LED

"ON"?

Yes

PRESS AND HOLD THE

"DUMP BUTTON " ON

THE MAIN LOGIC

BOARD. WHAT

NUMBER(S) ARE

DISPLAYED?

#02

#01

#04

#10

Hopper Exit window

is blocked. Please

do the following.

1. Remove all the

coins.

2. Take off the

Track side cover of

the hopper.

3. Remove the

object from the

window.

4. Reassemble the

hopper.

The hopper has a

low coin shut down.

Please do the

following:

1. Ensure the

hopper is full of

coins. Turn off the

machine, wait 5 sec.

then turn it back on

again.

2 Clean the 3 gold

plates at the bottom

of the hopper where

the coins are poured

in with a scotch

bright pad or emery

cloth.

3. Check continuity

of the wires from

the gold plates back

to the logic board.

The hopper is

jammed.

The hopper

overpaid by 2

to many coins

and was shut

down. Replace

the hopper or

the hopper

harness.

Is the GREEN

LED on the

main logic

board on?

Yes

Is the On/

Off (I/O)

switch on?

(I pressed

down?)

Yes

Is the

120VAC plug

pushed into

the bottom of

the logic

board and into

the wall?

Yes

Using a

meter check

the 2-amp

fuse. Is it

good good?

Yes

Check the 120VAC

wall breaker.

Replace the FUSE

then the logic board.

Will the CoinCo bill

acceptor attempt to

pull bills in at all?

Are the RED bill

meter numbers lit

on the main logic

display?

Yes

YES

It appears as if your CoinCo is

dirty or the belts are worn. Please

try the following:

1. Go to Page 7 and perform the

cleaning procedure.

2. If that is unsuccessful inspect

the plastic lower housing for deep

scratches or VANDALISM.

3. If the CoinCo has accepted over

50,000 bills it could need new

belts.

The CoinCo is

flashing an

"ERROR CODE".

Please go to the

CoinCo Error code

section of this

manual. Page 8.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 44 45

Comentarios a estos manuales

Sin comentarios

Black Box AC2000A Especificaciones Pagina 30

Comentarios a estos manuales

Relacionado con productos y manuales para No Black Box AC2000A