Black Box AC2000A Especificaciones descargar pdf (Pagina 21)

21

Coupon Configuration

The AE2601 may be configured using a coupon.

The coupon is included in the AE2601 Series

Installation Guide. Carefully cut the coupon

along

the dotted-line edge to remove it from the

installation guide. Copies of the original coupon

may be produced with a standard, carbon-

based,

non-color copier. Cut copies to match the size of

the original coupon.

All option switches must be in the OFF

position for the coupon selections to be

active.

The coupon selection will remain with the

AE2601 until the unit is reprogrammed, even if

power is removed.

When filling out the coupon, note the following:

Use only a #2 pencil to fill in the blocks

Fill in the entire block

Do not mark the coupon outside the blocks

or on the back of the coupon

Fill in ONE block for EVERY line

Coupon Programming

1. Fill out the coupon using the table below.

2. Locate the service button on the back of the

unit (refer to Figure 2).

3. Press the button once to enter the coupon

setup mode. Pressing again will exit the

mode. The unit will automatically exit coupon

setup mode upon acceptance of the

coupon configuration.

The LED Status indicator (located to the left of

the service button) will flash rapidly

indicating that the unit is in coupon setup mode.

4. Insert the coupon marked-side up.

The AE2601 will pull the coupon in, read it, and

then return it to the user.

A good coupon will be returned immediately.

After the coupon is pulled from the bill

acceptor mouth, the unit will flash the Status

LED ten times to confirm a good

configuration.

A bad coupon will be held for ten seconds before

being returned. This delay is to

make you aware that there is a problem with

the coupon. When the coupon is pulled

from the bill acceptor mouth, the unit will flash

the Status LED the number of times

corresponding to the section of the coupon

wherein a problem lies. For example, if

THIS IS NOT A USABLE COUPON!

DO NOT COPY!!!

FIGURE 1

FIGURE 2

the problem is in section five, the LED will

flash five times. Section numbers are

located to the far right of each section on the

coupon.

5. If the configuration is rejected, check the

coupon and repeat the process.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 44 45

Comentarios a estos manuales

Sin comentarios