APPENDIX A: Configuration Charts
143
Chart A-4: Configurations of channels with Expansion Receive Cards installed.
*If you look at the Card’s HD26 or RJ-45 connector(s) from the rear, the Card’s label is to the right of the connector(s).
†If this port is connected to a matching port on a Transmit Card in a ServSwitch Multi Base Unit, MX, EXP, or SB, record that Transmit-Card port’s switch address
and channel letter here. If this port is connected to a port on a Transmit Module in a ServSwitch Multi Hub, record that Transmit-Module port’s switch address,
slot letter, and channel number here.
Switch Chanl. Card-Label Jumper DIP-Switch Port 1 (Lower) Port 2 (Upper)
Address Letter Info* Settings Settings Attached To† Attached To†
Comentarios a estos manuales