Black Box LES1204A-R2 Manual de usuario descargar pdf (Pagina 178)

Chapter 14: Command Line Confguration

178 724-746-5500 l www.blackbox.com

To use NAGIOS to notify of this alert

# config -s config.alerts.alert2.nsca.enabled=on

To use SNMP to notify of this alert

# config -s config.alerts.alert2.snmp.enabled=on

Increment the total alerts:

# config -s config.alerts.total=2

Below are the specific settings depending on the type of alert required:

Connection Alert

To trigger an alert when a user connects to serial port 5 or network host 3:

# config -s config.alerts.alert2.host3='host name'

# config -s config.alerts.alert2.port5=on

# config -s config.alerts.alert2.sensor=temp

# config -s config.alerts.alert2.signal=DSR

# config -s config.alerts.alert2.type=login

Signal Alert

To trigger an alert when a signal changes state on port 1:

# config -s config.alerts.alert2.port1=on

# config -s config.alerts.alert2.sensor=temp

# config -s config.alerts.alert2.signal=[ DSR | DCD | CTS ]

# config -s config.alerts.alert2.type=signal

Pattern Match Alert

To trigger an alert if the regular expression '.*0.0% id' is found in serial port 10's character stream.

# config -s "config.alerts.alert2.pattern=.*0.0% id"

# config -s config.alerts.alert2.port10=on

# config -s config.alerts.alert2.sensor=temp

# config -s config.alerts.alert2.signal=DSR

# config -s config.alerts.alert2.type=pattern

UPS Power Status Alert

To trigger an alert when myUPS (on localhost) or thatUPS (on remote host 192.168.0.50) power status changes between

on line, on battery and low battery.

# config -s config.alerts.alert2.sensor=temp

# config -s config.alerts.alert2.signal=DSR

# config -s config.alerts.alert2.type=ups

# config -s config.alerts.alert2.ups1=myUPS@localhost

# config -s config.alerts.alert2.[email protected]

Environmental and Power Sensor Alert

# config -s config.alerts.alert2.enviro.high.critical='critical value'

# config -s config.alerts.alert2.enviro.high.warning='warning value'

# config -s config.alerts.alert2.enviro.hysteresis='value'

# config -s config.alerts.alert2.enviro.low.critical='critical value'

# config -s config.alerts.alert2.enviro.low.warning='warning value'

# config -s config.alerts.alert2.enviro1='Enviro sensor name'

# config -s config.alerts.alert2.outlet#='RPCname'.outlet#

1 2 ... 173 174 175 176 177 178 179 180 181 182 183 ... 234 235

Comentarios a estos manuales

Sin comentarios

Black Box LES1204A-R2 Manual de usuario Pagina 178

Comentarios a estos manuales

Relacionado con productos y manuales para Servidores De Consola Black Box LES1204A-R2