Black Box LWN600CM-1 Guía de usuario descargar pdf (Pagina 48)

724-746-5500 | blackbox.com

Page 48

724-746-5500 | blackbox.com

Chapter 3: The SmartPath AP (LWN602HA) Overview

Mounting Plate

Press the track clips against the

ceiling track and swivel them until

they snap into place, gripping the

edges of the track.

If necessary, slide one or both of

the clips along the track to position

them at the proper distance (2 1/4”

or 7 cm) to fit through the holes in

the mounting plate.

Insert the mounting plate over the

screws attached to the track clips,

and use the Keps nuts to fasten

the plate firmly to the screws on

the clips.

Use a wrench to tighten the nuts

firmly to the bolts and secure the

plate to the track.

Through the oblong opening in the

plate, drill a hole in the ceiling tile (not

shown). Then pass one or both

Ethernet cables through the hole, and

if you plan to supply power from an

AC power source rather than through

PoE, pass the power cable through

as well.

Drill a hole in the ceiling tile

and feed cables through here.

Ceiling Track

Track Clip

(worms’s eye view with ceiling

tiles removed for clarity)

2 1/4 “ (7 cm)

⁄4" (7 cm)

⁄4"

Worm’s eye view with ceiling

tiles removed for clarity.

Figure 3-12. Attaching the track clips and mounting plate to the ceiling track.

Attach the SmartPath AP to the mounting plate and connect the cables, as shown in Figure 3-13.

NOTE: You can tie the cables to the tie points (small arched strips) on the mounting plate to prevent them from being pulled out

of their connections accidentally.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 191 192

Comentarios a estos manuales

Sin comentarios

Black Box LWN600CM-1 Guía de usuario Pagina 48

Comentarios a estos manuales