Black Box LBG1000A-R2 Manual de usuario descargar pdf (Pagina 29)

Add/Delete Routing Table Entries

Step 2: Press <Shift> and [+] on keypad to enter Route Options as shown below.

Step 3: Press [-] to delete an entry in the routing table.

Search for Routing Table Entries

Step 4: Press <S> to search a network address. Enter the network address you want you are looking for.

DHCP GATEWAY SETTINGS

Step 1: Move to highlight [DHCP Gateway Settings] from [IP Networking] and press <Enter>.

Step 2: Move to highlight a row you want to change the DHCP Gateway Settings, and press <Enter>

Add/Delete Relay IP

Step 3: Press <Shift> and [+] on keypad to add a relay IP. Choose a suitable interface or All Interfaces from Select

Outbound Relay Interfaces.

Otherwise, you may press [-] on keypad to delete a relay IP.

DHCP Gateway Options

Step 4: Move to highlight DHCP Gateway and press <Enter>.

Decide to have it Disabled or Enabled.

Maximum Hops

Step 5: Move to highlight Maximum Hops and press <Enter>

Step 6: Enter decimal number (1-16) to configure the maximum number of hops.

Delay (sec)

Step 7: Move to highlight Delay (sec) and press <Enter>.

Step 8:Enter decimal number (0-65535) configure the delay in seconds.

Preferred Server

Step 9: Move to highlight Preferred Server and press <Enter>.

Step 10: Enter IP address for the Preferred Server.

Step 11: To specify up to three more Preferred Servers, repeat the above steps.

* No precautionary message appears before you delete an entry

from the routing table.

Be sure you want to delete it before doing so.

* No precautionary message appears before you delete a relay IP.

* Be sure you want to delete it before doing so.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 73 74

Sin comentarios

Black Box LBG1000A-R2 Manual de usuario Pagina 29