Black Box TS255A Especificaciones descargar pdf (Pagina 22)

Ports, LEDs, and power connectors

Chapter 2 Copper TAPs

rev. 1

and Link A then must use the same speed as Link B. If your link is

under test as part of a failover or redundancy arrangement, then

connect the failover device to Link B. See “How do I connect my

failover devices?” on page 55.

3 Connect your network device (or primary device in a failover

arrangement) to Link A.

4 Connect the Analyzer ports on the TAP to the dual-receive

interface on the monitoring device.

OTE: TAP NOT

CONNECTING

If you are attempting to connect to a device with a 1000 Mb

NIC and your 10/100 TAP is not linking, this is likely due to

the auto-negotiation feature. To allow the TAP to connect,

you must force the NIC in your device to 100 Mb full duplex.

Ports, LEDs, and power connectors

This section provides a brief overview of installing the TAP and

understanding the status LEDs.

The front panel will differ slightly depending on which TAP model

you have purchased. The 10/100 (not shown) does not have the 1000

Mb speed indicator light.

Figure 5 10/100 and 10/100/1000 Copper TAP

Both power connectors are located on the back panel, along with the

model information and serial number. You can supply power to either

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 63 64

Sin comentarios

Black Box TS255A Especificaciones Pagina 22