Black Box TS255A Especificaciones descargar pdf (Pagina 20)

Installing the Copper TAP

Chapter 2 Copper TAPs

rev. 1

 Patch cable(s)

 Redundant power supply

 Rack or bay mount

If any part is missing or damaged, contact Black Box Support

immediately.

Installing the Copper TAP

After reviewing the information in “Deciding whether to use a TAP or

a SPAN/mirror port” on page 8 and “Choosing between a SPAN,

Aggregator, or full-duplex TAP” on page 10, you decided a Copper

TAP was the right one for you. Use the information in this section to

install your TAP.

To install the Copper TAP, you must:

 Decide where to place the TAP, and physically mount it, if

desired. This will be in a PC drive bay, rack mount bracket, or

wherever it is most convenient. For efficient heat dissipation,

keep the TAP horizontal.

 Use standard Ethernet cables with RJ-45 connectors to

complete the pass-through connection between the device of

interest and the network. The 10/100 TAP must use straight-

through cables. It cannot use crossover cables. The 10/100/

1000 TAP may use crossover cables. See “Choosing crossover

or straight-through cables” on page 57.

 Connect the TAP to your analyzer or other monitoring device

using standard Ethernet cables.

The Copper TAP transmits the analyzer signals through a pair of 10/

100 or 10/100/1000 BaseT RJ-45 ports.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 63 64

Sin comentarios

Black Box TS255A Especificaciones Pagina 20