Black-box COMPACT T1 MT850A Manual de usuario Pagina 340
- Pagina / 592
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
5-256 Compact T1 - Release 6.1
CLI Commands
status
status (ds0)
Use the status (ds0) command to display the current status of the specified DS0.
Syntax: status {ds0-addr}
Example: status a:1:1
Displays the current status of the DS0s on port 1 on slot A
(controller card), port 1, channel 1.
> status a:1:1
DS0 Rx AB Tx AB Signal T1 TP
--- ----- ----- ------ --------- --
A:1:1 11 01 EMW Traffic N
Display Descriptions
Rx AB - AB bits received by the FXS or FXO port
Tx AB - AB bits transmitted by the FXS or FXO port
Signal - Signaling mode for which the port is configured
T1 - T1 Status
TP - Trunk Processing
{ds0-addr}
In the form of {slot:port:channel}.
slot A for the controller card, or 1-6 for service cards.
port Port number or range.
channel Channel number or range, for T1 ports.
- Compact T1 1
- Supporting Software Version: 2
- Controller 6.1 2
- IP Router 1.6 2
- CMG Router 2.0 2
- Compliance 3
- Interference Statements 5
- Preface 7
- Safety Information 8
- NOT HANDLE ICS 10
- TABLE OF CONTENTS 11
- 2 Physical Installation 12
- 4 Configuration 13
- 5 CLI Commands 14
- Table of Contents 15
- Table of Contents 16
- 6 T1 Controller Card 22
- 7 FXO Voice Card 23
- 8 FXS Voice Card 23
- 9 ISDN BRI Card 24
- 10 OCU-DP Card 24
- 11 Power Supply 25
- 12 Quad T1 Card 26
- 13 Router (IP) Card 26
- 14 Router (CMG) Card 27
- 15 V.35/V.54 Cards 28
- 16 Maintenance 29
- A SNMP Interface 29
- Glossary 30
- Base Platform 31
- Overview 32
- Features 33
- Dual T1 Controller 33
- Power Supply 33
- Service Cards 34
- IP Router Service card 35
- CMG Router Service card 35
- Local and Remote Management 36
- Technical Specifications 36
- Base Platform 37
- Physical Information 39
- T1 and 10Base-T Ethernet 42
- Physical Installation 43
- Unpacking and Inspection 44
- Installation Environment 44
- Assembly of Unit 45
- Wall Mounting 46
- Physical Installation 47
- In this Chapter 51
- Compliant Installation 52
- Ferrite Beads 53
- Interface Connectors 54
- Chassis Ground Connector 55
- Power Reset 56
- Power Connections 56
- Battery 57
- Return (+) 57
- -48 VDC (-) 57
- External Alarm Connector 58
- 25-Pair Telco Connectors 59
- T1 Connection Ports 62
- 10Base-T Ethernet 62
- Setting up a CLI Connection 64
- System Information 65
- Basic System Setup 66
- Set Up Security 67
- Set Up a DS1/T1 67
- Set Up a DS0/Channel 68
- Set Up an Analog Port 68
- Set Up the Router Card 69
- Set Up a ISDN BRI Service 70
- Set Up the OCU-DP Card 71
- Set Up a V.35 Port 72
- Configuration 73
- Quick Configuration Reload 74
- from the menu bar 75
- Equipment Required 78
- Application Overview 78
- Operation 78
- Configure the Router 79
- Setup the Profile for Site A 80
- Setup the Profile for Site B 80
- Setup the Profile for Site C 81
- Remote Site A Configuration 81
- Remote Site B Configuration 82
- Remote Site C Configuration 83
- Command Line Interface Help 86
- CLI Commands 100
- Example: set ntp timezone -5 169
- [minute-offset] 212
- 322
- Display Descriptions 340
- T1 Controller Card 371
- Management 375
- Network T1 Interface 375
- Service Interfaces Supported 376
- Network Standards 376
- Clocking 376
- Testing and Diagnostics 377
- Power Consumption 377
- Regulatory Approvals 377
- Physical 377
- Configuration 378
- DIP Switch Settings 379
- 0 (Off) 1 (On) 380
- DS0 Management (IP over DS0) 381
- TR-08 Mode 1 382
- FXO Voice Card 385
- FXO Transmission Performance 388
- FXO Signaling Performance 388
- Card Configuration 390
- Conversions 393
- FXS Voice Card 395
- FXS Signaling Performance 399
- ISDN BRI Card 405
- Testing & Diagnostics 409
- Product Supports 409
- Connector Pinouts 413
- SLOT 1 on J1 or SLOT 4 on J2 414
- SLOT 2 on J1 or SLOT 5 on J2 414
- SLOT 3 on J1 or SLOT 6 on J2 415
- OCU-DP Card 417
- Customer Premise Application 419
- SS7 Backhaul Application 420
- Basic Setup 425
- Jumper Settings 427
- Line Rates/Line Lengths 429
- 25-Pair Telco Connector 431
- Ringing Generators 436
- Input Power 437
- 115 VAC LEDs 438
- Ringer Waveform Options 439
- Standard Waveform 440
- Square Waveform 441
- Replacing a Power Supply 443
- Quad T1 Card 445
- T1 Interface 448
- Network Interface 448
- P2 and P3 Jumpers 451
- Front Back 451
- RJ-48 Connector 454
- Configuration Restrictions 456
- Router (IP) Card 457
- Controller Software Required 459
- Advanced Capabilities 461
- Frame Relay 461
- Filtering 461
- Security 461
- Router (CMG) Card 475
- Routing and Policy Management 479
- Router Performance 480
- TDM-Side Signaling 480
- Connector Pinout 494
- BroadSoft™ 495
- Compact T1 Settings 496
- V.35/V.54 Cards 499
- Accessories 503
- Maintenance 509
- Software Upgrade 510
- Maintenance 511
- Using HyperTerminal 514
- Using Procomm 514
- Save Controller Configuration 515
- Load Controller Configuration 516
- Replace Controller Card 517
- Hot Swap Service Card 517
- APPENDIX 519
- SNMP Basics 520
- Enterprise MIB Support 521
- Router Enterprise MIB Support 522
- SNMP Interface 523
- Public MIB Support 524
- Router Public MIB Support 525
- SNMP Trap Reports 526
- Enterprise Traps 527
- SNMP Interface 528
- Test Alarm 530
- Identify Alarm 530
- Compact T1 - Release 6.1 B-3 531
- Clear Alarm 532
- Example: log 533
- Status and Performance 534
- Loopbacks Overview 535
- DS1 Loopbacks 536
- DS1 Payload Loop 537
- Receiving DS1 CSU Loop 538
- Compact T1 - Release 6.1 B-11 539
- DS1 Equipment Loop 540
- Compact T1 - Release 6.1 B-13 541
- View Status of Loopback 541
- V.35 Loopbacks 542
- Compact T1 - Release 6.1 B-15 543
- Disable Line Loopback 543
- V.35 Equipment Loop 544
- Compact T1 - Release 6.1 B-17 545
- Disable Equipment Loopback 545
- V.35/V.54 Loop 546
- V.54 Loop 547
- B-20 Compact T1 - Release 6.1 548
- V.54 Equipment Loopback 549
- B-22 Compact T1 - Release 6.1 550
- Disable V.54 Equipment Loopup 550
- OCU-DP Loopbacks 551
- Non-Latching Loopdetect 552
- CSU Manual Loopback 553
- Manual OCU Loopback 554
- Compact T1 - Release 6.1 B-27 555
- Verification 556
- Statistics 556
- System Reports 557
- B-30 Compact T1 - Release 6.1 558
- GLOSSARY 559
- Glossary 561
Relacionado con productos y manuales para Hardware Black-box COMPACT T1 MT850A
Hardware Black-box GEH-6510 Manual de usuario
(92 paginas)
(92 paginas)
Hardware Black-box IC136C Manual de usuario
(23 paginas)
(23 paginas)
Hardware Black-box 7000 T1/E1 Manual de usuario
(4 paginas)
(4 paginas)
Hardware Black-box RM 415A Manual de usuario
(1 paginas)
(1 paginas)
Hardware Black-box EVNSL17A Manual de usuario
(1 paginas)
(1 paginas)
Hardware Black-box 21834 Manual de usuario
(2 paginas)
(2 paginas)
Hardware Black-box LRU4240 Manual de usuario
(218 paginas)
(218 paginas)
Hardware Black-box CAT5E Manual de usuario
(2 paginas)
(2 paginas)
Hardware Black-box CAT6a Manual de usuario
(2 paginas)
(2 paginas)
Hardware Black-box Modem Manual de usuario
(3 paginas)
(3 paginas)
Hardware Black-box COMPACT T1 Manual de usuario
(42 paginas)
(42 paginas)
Hardware Black-box G703/V.35 Manual de usuario
(3 paginas)
(3 paginas)
Hardware Black-box CAT6 Manual de usuario
(3 paginas)
(3 paginas)
Hardware Black-box 25357 Manual de usuario
(2 paginas)
(2 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.062 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales