Black Box IC108A Guía de instalación descargar pdf (Pagina 28)

ISC Communications

170 —

revision 1

6. You can close your current HyperTerminal session.

Step 3: Configure the UDS ETHLAN

Make sure that the device is powered up, completely booted, and connected to the Network.

1. Start Telnet.

2. From the connect menu, connect to the device using the IP address, Port address of 9999, and terminal

type of VT100.

3. You will see the same configuration screen as before, now hit <Enter> and go into the setup.

4. At the selections prompt, type 1 and hit <Enter> to go into the Channel Configurations menu.

5. Once you are in the setup for channel 1 configuration, please make the following changes:

a. Baud rate = 38400

b. I/F mode = 4C. See

Common I/F Mode Valueson page 176.

c. Flow Control = 02. See Common Flow Control Valueson page 176.

d. Port Number = 3001

e. Connection Mode = C0

f. Remote IP Address = (000). (000). (000). (000)

g. Remote Port = 00000

h. DisConnMode = 00

i. Flush Mode = 00

j. Disconnect Time = 00:00

k. Send Char 1 = 00

l. Send Char 2 = 00

6. Once these settings have been properly configured, enter 9 at the prompt to save changes and exit.

7. Close the Telnet session.

8. Cycle the power manually on the UDS and let it reboot.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 34 35

Sin comentarios

Black Box IC108A Guía de instalación Pagina 28