Black Box IC108A Guía de instalación descargar pdf (Pagina 17)

Hardware Installation Guide

revision 1 — 159

3. You will now be back at the setup screen. Type 9 and then press the <Enter> key to save the setup

information and exit the CoBox setup menus.

4. The device is now configured to work with the network. Power the machine down, connect it to the

network, and then power it up.

Step 3: Connecting the ISC to the CoBox Device

1. Connect the ISC to the CH2 port of the CoBox device using a direct connection cable according to the

cable pinout table below.

2. Add the panel in the System Administration application, using the IP address of the CoBox. This is the

same IP address that was entered in Step 1, procedure number 10.

3. Run the Access Control Driver and Alarm Monitoring applications. Verify that the panel came online.

Cable Pinouts

ISC 9-pin female

TXD/TR1+ pin 2

RXD/TR1- pin 3

RTS/R1+ not used

CTS/R1- pin 7

GND pin 5

Jumper together 4,6 & 8

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 34 35

Sin comentarios

Black Box IC108A Guía de instalación Pagina 17