Black Box SWI081A Manual de usuario descargar pdf (Pagina 22)

DUAL-PORT NETWORK POWER SWITCH

4.3 Switch Command/Menu Conventions

When invoking Dual-Port Network Power Switch commands and selecting items

from configuration menus, note the following:

• All Dual-Port Network Power Switch commands can be invoked at the TPS>

command prompt, or from the General Parameters menu, Port Parameters

menus, or Network Parameters menu.

• Dual-Port Network Power Switch commands are not case sensitive. All Dual-

Port Network Power Switch commands are invoked by pressing [Enter].

• To select an item from a Dual-Port Network Power Switch menu, key in the

number for the item and press [Enter]. To exit from a menu, press [Esc] at any

time. Parameters defined up to that point will be saved.

• To display the Help Screen, type /H [Enter].

• The ,Y option can temporarily suppress the “Sure?” confirmation prompt.

The ,Y option is entered at the end of the command line, immediately

following the command or argument. For example, to reset the network port

without displaying the “Sure?” prompt, type /T,Y [Enter]. To switch off Plug 2

without the “Sure?” prompt, type /OFF 2,Y [Enter].

4.4 Defining General Parameters

When the “TPS>” prompt appears, type /G [Enter] to display the General

Parameters menu (Figure 4-3). Note that this menu is not available in User mode.

Figure 4-3. General Parameters menu (System mode only).

GENERAL PARAMETERS:

1. System Password: (undefined)

2. Site ID: (undefined)

3. Modem Init. String: ATE0M0Q1&C1&D2S0=1

4. Modem Disc. String: (undefined)

5. Baud Rate: 9600,N,8,1

6. Command Echo: Off

7. Disconnect Timeout: 2 Min

8. Command Confirmation: On

9. Automated Mode: On

10. Button Mode: On

A. Default Parameters

Enter Selection or <ESC> to Exit…

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 43 44

Sin comentarios

Black Box SWI081A Manual de usuario Pagina 22