Black Box PG-DIG Ficha de datos descargar pdf (Pagina 11)

724-746-5500 | blackbox.com Page 9

Chapter 4: Operation

4. Operation

4.1 Starting Status (Power Switch On Mode)

P01 640x480 @60

DVI MENU

Figure 4-1. Starting Status mode.

1. To start the pattern generator, press the power on/off key for 2-3 seconds. It will

sound a long beep. The part number and the firmware version will display.

2. Press a function key (found below the LCD display). The PG-DIG will sound a

short beep confirming your selection.

3. The factory-preset starting value is P01 640x480 @60, where:

P01=Pattern 01

640x480=Resolution 640x480

@60=Refresh rate 60 Hz

4. The bottom left corner of the LCD displays the current status:

a. HDMI mode:

DVI: output signal is DVI

H8: output signal is HDMI 8 bit

H10: output signal is HDMI 10 bit

H12: output signal is HDMI 12 bit

b. Video type (refer to EIA/CEA-861B standard)

RGB: RGB

Y444: YCbCr 4:4:4

Y422: YCbCr 4:2:2 (if PG-DIG operates on DVI mode, then video type is RGB

(4:4:4 with 8 bits component)

c. HDCP: the HDCP engine has started

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

Sin comentarios

Black Box PG-DIG Ficha de datos Pagina 11