Black Box V5.1 Guía para resolver problemas descargar pdf (Pagina 30)

Euro MotoElectrics, 25958 Genesee Trail Road PMB 321 Golden, Colorado USA 80401 EDL-IGN Page 30 of 43

www.EuroMotoElectrics.com info@euromotoelectrics.com Tel: 1-303-526-0901

EnDuraSpark Electronic Ignition

Installation & Troubleshooting v5.1

This step creates the grommet that presses on the

wires coming out the top of the front engine cover.

Cut weather stripping, part #13, along the white lines shown

with diagonal cutters (dykes).

Snip off the ends of the top layer along the dotted lines:

The final grommet will look like this:

Install the grommet created in the previous step on the top

of the front engine cover, centered as shown.

For 1970-1978 models which have left the original points ignition installed,

start the front cover installation by aligning the ignition wire rubber with the

corresponding cut-out in the engine cover.

Secure the cover over the top right alignment pin and bolt the

cover down evenly. This pin is on the bottom for 1979-1990

models.

Step 30: Create Top Grommet

Wheel Hub

Step 31: Install Front Cover

Wheel Hub

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 42 43

Sin comentarios

Black Box V5.1 Guía para resolver problemas Pagina 30