Black Box InvisaPC DTX1000-T Guía de usuario descargar pdf (Pagina 21)

Chapter 2: Installation

724-746-5500 l www.blackbox.com

Table 2.1: Figure 3 Descriptions

Number Description

PC or Workstation

2 InvisaPC Transmitter

3 IP network – 100Mbps

4 InvisaPC Receiver

5 User Peripherals –

keyboard, mouse,

monitor

To connect the InvisaPC Transmitter:

Before connecting the InvisaPC Transmitter to the remote workstation, ensure that the

resolution

and the refresh rate of the remote workstation are supported by the InvisaPC

Transmitter. Set the

screen resolution and refresh rate of the remote workstation.

Unsupported settings will cause blank

video or distorted video at the Receiver.

Turn off the remote workstation.

The InvisaPC Transmitter has one USB connector. Connect it to a

corresponding

USB port on the remote workstation (a USB 2.0 port on remote workstation for

best performance). Connect using the provided USB cable.

Connect the video connector on the InvisaPC Transmitter to the appropriately

labeled port on

the workstation using the provided DVI cable.

Connect one end of the UTP cable to the InvisaPC Transmitter’s RJ-45 connector

and turn on

the workstation.

Route the other end of the UTP cable to the location you have chosen for the

InvisaPC Receiver. If necessary, you can extend the UTP cable via junctions or an

Ethernet switch (subject to normal

Ethernet cabling practices).

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 57 58

Sin comentarios

Black Box InvisaPC DTX1000-T Guía de usuario Pagina 21