Connections at the remote module
Video connection
1 Connect the DVI/D lead from the video monitor to the DVI output socket of
the remote module.
Link connection
1 Attach one of the supplied ferrite cores to the link cable, next to the
connector. This is necessary to ensure compliance with the European EMC
directive and FCC regulations.
2 Connect the link cable (see page 2 for cable advice) to the remote module
socket labelled TO LOCAL.
3 If necessary, use video compensation to overcome the effects of long cable
lengths on the video signal - see page 7 for details.
Power connection
1 Connect the output lead of the
supplied power adapter to the
socket labelled ‘POWER‘ on the
remote module.
2 Insert the IEC connector of
the separate power lead
into the corresponding
socket of the power
adapter. Connect the
other end of the power
lead to a nearby mains
socket.
Comentarios a estos manuales