Black Box SW722A-R2 Especificaciones descargar pdf (Pagina 14)

“R2” SERVSWITCH

NEXT: Next Port Button: Press this button to manually switch the shared

monitor, keyboard, and mouse from the currently selected computer to

the next one in sequence.

SCAN: Scan-Mode Button: When the ServSwitch is ON and operating normally

(not scanning), press the button once to put the button in the “in”

position. This causes the unit to begin automatic sequential scanning of

connected ports. (If the scan does not begin immediately, quickly press the

button twice more, so that it moves to the “out” position and back to the

“in” position again.) Pressing the button again (returning it to the “out”

position”) ends the scan. For normal operation, the SCAN button should

be “out.” If the system doesn’t function normally after you return the

SCAN button to the “out” position, perform a factory reset (see Section

5.1).

2.4 The Rear Panel

All cable connections are made at the ServSwitch’s rear panel, as illustrated in

Figure 2-2 and described on the next page.

Figure 2-2. The rear panel of a KVM 4 to 1 ServSwitch (SW722).

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 47 48

Sin comentarios

Black Box SW722A-R2 Especificaciones Pagina 14