Black Box ServSwitch Wizard Especificaciones descargar pdf (Pagina 38)

SERVSWITCH™ WIZARD

5. Operation

This chapter explains how to operate the ServSwitch Wizard. Please read this

chapter carefully before starting to use the Wizard; also make sure you have read

the important note at the start of Chapter 4.

5.1 Power Status

At power-up, the ServSwitch Wizard will try to select CPU channel #1 unless

(a) a password has been set or (b) the Wizard isn’t getting enough power to operate

properly. Watch the Wizard’s front-panel 7-segment display, as described in

Figure 5-1: If the Wizard is not receiving enough power, the display will be blank; if

the Wizard can select CPU 1, the display will show “1”; or if a password has been

set, the Wizard will display “P” and remain locked until a valid password is entered.

(For the meaning of this display after power-up, see Section 5.3.)

Figure 5-1. The front-panel status display at power-up.

DISPLAY SHOWS:

Blank

The number “1”

The letter “P”

MEANING:

Switch is not receiving nearly

enough power to operate

Switch has powered up normally

and has selected channel 1

Switch has powered up normally

but is locked and is waiting for

the password to be entered

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 59 60

Sin comentarios

Black Box ServSwitch Wizard Especificaciones Pagina 38