Black Box Switch PQ-8S Manual de usuario descargar pdf (Pagina 19)

PQ-8P, PQ-8S

4. Configuration

2. Make sure the PQ-8 is properly

connected to the twinax host

and the correct device address

is set.

3. Power on the PQ-8. The AS/400

will auto-configure the printer

address according to the PQ-8

settings.

If you are using an S/3X host, you

must configure the host manually.

Table 4-1 shows the recommended

emulation and device ID for the

different host systems.

4.1 Host Configuration

Before operating the PQ-8 in twinax

mode, the IBM host must be

configured with a device address and

device ID for the printer. See your

system operator or system manual

for details. With the correct address

selected, an AS/400 will

automatically configure itself

according to the active IBM printer

emulation on the PQ-8.

1. Make sure you have selected and

permanently stored the desired

IBM emulation on the PQ-8.

This can be done through the

setup software or Host/PC

download command Z24 (to

select emulation) followed by

command Z99,0 (to save).

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 167 168

Sin comentarios

Black Box Switch PQ-8S Manual de usuario Pagina 19