Black Box SW551A Guía de usuario descargar pdf (Pagina 12)

SECURE SITE MANAGERS

2. Quick Start Guide

This section describes a simpliﬁed installation procedure for the Secure Site

Managers, which will allow you to communicate with the unit in order to

demonstrate basic features and check for proper operation.

Note that this Quick Start Guide does not provide a detailed description of unit

conﬁguration, or discuss advanced operating features in detail. In order to take full

advantage of the features provided by this unit, it is recommended that you should

complete the entire Installation and Conﬁguration sections after performing this

Quick Start procedure.

2.1. Quick Hardware Installation

2.1.1. Apply Power to the Secure Site Manager

Refer to the safety precautions listed at the beginning of this User’s Guide and in

Section 4, and then connect the unit to an appropriate power source. Note that

Secure Site Manager units are designed for 100 to 240 VAC, 50/60 Hz operation and

feature an auto sensing power supply.

When power is applied to the Secure Site Manager, the ON LED should light, and

the RDY LED should begin to ﬂash. Note however, that the boot up procedure may

take up to two minutes; this delay is due to the time required to generate SSH keys.

2.1.2. Connect your Control Device to the Secure Site Manager

The Secure Site Manager can either be controlled via local PC Serial Port, modem,

or TCP/IP network. In order to connect ports or select parameters, commands are

issued to the Secure Site Manager via either the Network Port, Modem or RS232

Setup Port. Note that it is not necessary to connect to both the Network and Setup

Ports, and that the Setup Port can be connected to either a local PC or an external

modem.

• Network Port: Connect your 10Base-T or 100Base-T network interface to

the Secure Site Manager 10/100Base-T Network port.

• Console Port: Use the supplied null modem cable to connect your PC COM

port to the Secure Site Manager Set-Up Port (RS232).

• Modem: Connect your phone line to the Secure Site Manager’s Phone Line

(Modem) port.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 117 118

Sin comentarios

Black Box SW551A Guía de usuario Pagina 12